Meet on April 25th-->The new thread
#81
New Member
Join Date: 02-08-09
Location: Truro, Nova Scotia
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
#92
New Member
Join Date: 03-04-09
Location: Nova Scotia, Canada
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Got my car into halifax to get it dynoed but there was a twin turbo z06 corvette there and I didn't get my car on the dyno. On the way back home (still my first day on the road) I took the main input shaft bearing out of the tranny. I have the tranny pulled out again, getting the tranny fixed, sending it back to the paint shop to fix up a few things and then heading to halifax to get it tuned/dynoed on the 11th. It will be close but I am determined to get the damn car running by the 25th! Can't wait to get get it running.
#96
New Member
Join Date: 03-04-09
Location: Nova Scotia, Canada
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
You better get it running I'm going crazy over here cause car issues but I'm gonna have it running if its the last thing I do in my life...main input shaft bearing is installed in tranny, they are putting the tranny back in monday and then off to the body shop...you better get it fixed RuSh!
#97
Senior Member
Thread Starter
iTrader: (1)
Join Date: 11-29-06
Location: New Minas, Nova Scotia, Canada
Posts: 4,105
Likes: 0
Received 0 Likes
on
0 Posts
well, from the research i did, it seems like there are good chances that its an axle seal, which isnt that bad. Im hoping thats all it is. I should be able to make, but again, more on tuesday at 2pm..
#100
Member
Join Date: 02-24-09
Location: New Minas, Nova Scotia, Canada
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts