The True Short Shifter Has Arrived
#10
Senior Member
I dont see the point of shortening your leverage shaft.
the gain you get in shortening is ruined by the amount of increased force necessary to shift because your changing the wrong side of the pivot point.
the gain you get in shortening is ruined by the amount of increased force necessary to shift because your changing the wrong side of the pivot point.
#11
Senior Member
Thread Starter
Join Date: 12-06-05
Location: California
Posts: 726
Likes: 0
Received 0 Likes
on
0 Posts
it does not make a difference at all to me with the height ... it actually makes it a little easier for me .... plus i just have always love the nub look .... there was no "Performance" gain expected when doing this modification.... just personal preference .... also to have something that NO ONE else can / will offer
#18
Senior Member
I wouldn't mind a longer than stock shifter length if it had stock or shorter than stock throws. It would be right near the wheel, like a rally car. I miss Collin McRea.
#21
Senior Member
Join Date: 07-03-05
Location: South Bend , Indiana
Posts: 4,272
Likes: 0
Received 0 Likes
on
0 Posts
pclear9061 - Nice job man Mines not quite that short , but I did cut off 1.5" off my B&M stick and re-threaded it so I could use a 4th gen trans am knob .
#22
Senior Member
Thread Starter
Join Date: 12-06-05
Location: California
Posts: 726
Likes: 0
Received 0 Likes
on
0 Posts
i take the shifter that i purchase thru my wholesaler and then modify it to the correct app. .... if interested please pm me ..... thats the most i can say w/o getting in trouble with not being a supporting vendor ... sorry ........