303whp w/ the M62 and STOCK longblock. I'm I the highest?
#1
303whp w/ the M62 and STOCK longblock. I'm I the highest?
Dyno'd today.
Here are my performance mods.
Custom Tube Inc Header/Downpipe w/ 1.75" Primaries and 3" collector
Custom Tube Inc 3" Cat-back
Siemens 80# Fuel Injectors
E85
Ported outlet/Polished inlet
2.6" Pulley
HPTuners Custom Tune
ZZP 3" CAI
ZZP S3 Heat Exchanger
ZZP Dual Pass Endplate
GM Option B Kit
Is this the highest hp number for the M62 on the stock long block? No nitrous of course!
Here are my performance mods.
Custom Tube Inc Header/Downpipe w/ 1.75" Primaries and 3" collector
Custom Tube Inc 3" Cat-back
Siemens 80# Fuel Injectors
E85
Ported outlet/Polished inlet
2.6" Pulley
HPTuners Custom Tune
ZZP 3" CAI
ZZP S3 Heat Exchanger
ZZP Dual Pass Endplate
GM Option B Kit
Is this the highest hp number for the M62 on the stock long block? No nitrous of course!
#7
It is/will be the highest number posted in the Official Dyno thread. But I am not sure if all the results are in there.
https://www.cobaltss.net/forums/dyno-results-170/official-dyno-thread-194257/
https://www.cobaltss.net/forums/dyno-results-170/official-dyno-thread-194257/
#10
Senior Member
iTrader: (18)
Join Date: 12-20-07
Location: Jeannette, PA
Posts: 3,055
Likes: 0
Received 0 Likes
on
0 Posts
Congrats well done! E85 most certainly has its perks. I'd love to run it but the closest place to me is 20 miles away. You aren't the highest as has been said. You are likely the highest in more recent times who has posted dyno proof on here however.
TVS is still going to have a better powerband and more potential. Think about what a 2.6" on a TVS does. =)
TVS is still going to have a better powerband and more potential. Think about what a 2.6" on a TVS does. =)
#16
Senior Member
iTrader: (4)
Join Date: 07-23-07
Location: cordova, Maryland
Posts: 1,706
Likes: 0
Received 0 Likes
on
0 Posts
well it's not much more than what you have just not 80's or CORN can't get it around here witch makes no sence i drive miles of corn everyday why can't try make it around here
#21
No. I started to "Port" the inlet but then I realized that I suck at it so I basically polished the inlet smooth.
CTI mid lengh combo. Cat-less
http://www.ottperformance.com/store/...ader-22p38.htm
Link please.
Me too.
CTI mid lengh combo. Cat-less
http://www.ottperformance.com/store/...ader-22p38.htm
Me too.