Anyone have this?
Thread Starter
Senior Member
Joined: 07-30-07
Posts: 2,220
Likes: 0
From: Home: Utica, MI Current Location: Mobile, Alabama
Member
Joined: 10-04-07
Posts: 331
Likes: 0
From: colorado
pro sport gauges go to www.machv.com and check them all out!!
Thread Starter
Senior Member
Joined: 07-30-07
Posts: 2,220
Likes: 0
From: Home: Utica, MI Current Location: Mobile, Alabama
Its just crazy that this is like $60 for a full volt meter AND a wideband. The AEM unit is like $300+. I know it says something about bosch O2 sensors or whatever, but i would think you could buy any sending unit you want.
Senior Member
Joined: 03-01-07
Posts: 3,740
Likes: 0
From: Calgary/Fort McMurray, Alberta, Canada
NOTE: This cannot be used as a stand along wideband AFR with a bosch wideband 5 wire heated O2 sensor unless you are using a controller! (Our complete wideband AFR gauge is due out end of June)
I would honestly not buy it. If you are looking for a wideband gauge this needs an extra controller by the sounds of it, plus an extra O2 sensor....so it will probably end up costing you the same as it would for the AEM one or one from Autometer.
I would honestly not buy it. If you are looking for a wideband gauge this needs an extra controller by the sounds of it, plus an extra O2 sensor....so it will probably end up costing you the same as it would for the AEM one or one from Autometer.
Senior Member
Joined: 10-01-06
Posts: 5,134
Likes: 0
From: Maidstone, SK
It says you'd need a controller for the wide band... so you'd need to pick up an LC-1 to control the sensor.
