What Have You Done To Your Cobalt Today?
Senior Member
Join Date: 01-31-16
Location: Frozen Wasteland of the North
Posts: 5,216
Received 532 Likes
on
456 Posts
Yeah when I got the inspection the car had 5% tint all around, he told me to remove the front and I would pass and ha 35% was the limit for front windows
Senior Member
iTrader: (5)
https://www.dps.texas.gov/rsd/vi/con...windowTint.htm
looks like the rears can have whatever as long as you have mirrors. oddly enough the front is 25% which ive never heard of so yeah basically 35
looks like the rears can have whatever as long as you have mirrors. oddly enough the front is 25% which ive never heard of so yeah basically 35
Senior Member
iTrader: (1)
Originally Posted by keiserX13
did that to mine 4 years ago
Senior Member
The following users liked this post:
EmperorJJ1 (02-27-2018)
Senior Member
iTrader: (4)
Finally got my fe5 Sway bar in. Head assembled except one valve spring because I lost 2 locks. Time to wait even longer to get 2 locks then finally assemble the engine and put it back in. Gonna be legit!
inb4itdoesn'trun
inb4itdoesn'trun
Senior Member
iTrader: (4)
Not holding my breath this time. .030" milled/ported head, cams and valve springs from my original head, lsj gasket, head studs, gonna loop my heater hoses probably since I don't have an hvac box anymore. There's too much **** to go wrong.
Sssssshhhhhhhhhhhhhhhhhhhhhhhhhh
Sssssshhhhhhhhhhhhhhhhhhhhhhhhhh
Funny thing happened I purchased a new GM MAF sensor which arrived in the mail today & to my surprise when I opened the envelope & unrolled the bubble wrap I had not one but 2 bran new GM MAF sensors! I tripple checked my order form & my bank account & they only charged me for one ☝ so unless are cars are suppose to run ??♀ with 2 MAF sensors I have a backup!
Senior Member
iTrader: (1)
You had to drop the cradle to install the sway bar didn't you? I remember when I installed mine it looked impossible to do without dropping the cradle. As far as the lost keeper that is why you can see in my build thread I installed my valve springs in my living room lol.
Senior Member
iTrader: (4)
You had to drop the cradle to install the sway bar didn't you? I remember when I installed mine it looked impossible to do without dropping the cradle. As far as the lost keeper that is why you can see in my build thread I installed my valve springs in my living room lol.
Senior Member
iTrader: (1)
All you need is 4 jack stands to drop the subframe. You leave the engine and trans up in the car. Might be tougher to find a strong spot for the jackstands without under car rails though I guess.