Sl0wbaltSS

Getting piping tomorrow but after doing a good 8 pulls total from getting mad at dumb drivers to just going to a street far away and having fun this happens. I think I might know where the mesh thing that was there fell off, i'll have to check tomorrow. What's the part called too? It's gona take me awhile to find on engine crate though.


I'm getting the rest the the approx 1ft 2 inch piping tomorrow. Now it's time for black stuff all over the bumper!

ItalianJoe1

iTrader: (10)

Nice, melted the lip on the bumper. Not gonna be a cheap repair there.

kzak104

iTrader: (1)

lol, i didnt even realize people just chopped the muffler off without running the exhaust to the bumper...

Sl0wbaltSS

It probably melted easier because the damn stock tune is running lean as hell. It runs lean all the way until 5k and by them I shift at 6k so there's not much room for the exhaust gas to cool down. The part looked fine many days when I had gotten the muffler cut off, just until recent it completely melted because the rain stopped and it's been hot lately so the car has been running lean and the exhaust gases are really hot.

GreenySC2

Why didn't you extend it and what not.... I did originally my only issue was I left the tip to close to the bumper so I had the ugly black stuff all over the place

Mr Mall Cop

iTrader: (1)

Kind of common sense I would think

LNFTX

Quit **** talking the stock tune because of your stupidity. If it is running "lean as hell" its not because of the tune you got other other problems but we've established that already

StevoElSupremo

Thats why you run a pipe to the end dumb dumb...you're really not the brightest bulb are ya? yes hot air melts plastic durrrr

tuned08ss

Isnt stock exhaust diameter 2.5"?

Xmetalhead2003X

iTrader: (3)

I want to say 2 or 2 1/4". I know my Magnaflow was slightly larger than stock (2 1/4") on an l61. It's now at 2 1/2".

tuned08ss

I think its 2.5" on a lnf. Op ordered 2"

BPacak

slapbetcommissioner

iTrader: (3)

Stock exhaust on an Lnf is 2.5" with a 2.25 kink near the axle. Op should start replacing just before the twist beam with 2.5" for improvement...

And probably refrain from cutting without thinking in the future.

Shanedude

Lesson learned I hope :P

Gimpster

And this.... is why I shopped for the stockest Cobalt I could find.

c0de7477

x2

GreenySC2

It is 2.5 the tip is 3 though..... either way op is going to have some wiggle room and restriction.....

turbocharged717

yeah you should have at least something to put in it's place.

kzak104

iTrader: (1)

i never get black stuff on my bumper =\

user 72239

iTrader: (4)

Scion retard strikes again

LNFTX

This
But I do seem to have a rare factory option black tip

Sl0wbaltSS

I don't own the scion anymore you retard ****.

Cobalt_Daddy

i think the point is you did at one point..

Mr Mall Cop

iTrader: (1)

This thread got nasty

user 72239

iTrader: (4)

Doesn't matter. You had one and thought it was so fast. I am not the retard that cut off my muffler cause you are too cheap to buy an actual exhaust so you melted your bumper lol