Cobalt SS Network - 2.0 LSJ Engine How to Install the ZZP Modular Pulley for your Cobalt SS/SC

Page 3 of 3

Show 40 post(s) from this thread on one page

Cobalt SS Network (https://www.cobaltss.net/forums/)

- How to Guide (https://www.cobaltss.net/forums/how-guide-43/)

- - 2.0 LSJ Engine: How to Install the ZZP Modular Pulley for your Cobalt SS/SC (https://www.cobaltss.net/forums/how-guide-43/how-install-zzp-modular-pulley-your-cobalt-ss-sc-25841/)

Gr8Bndimi

05-04-2014 01:34 PM

Subscribed

Empty Pockets

06-03-2014 04:16 AM

subd

Zalador

06-28-2014 11:53 AM

This may be a silly question, but does a 3.0 pulley fit ok with the stock belt and tensioner?

droponikz

07-14-2014 04:02 PM

[QUOTE=Zalador;7366914]This may be a silly question, but does a 3.0 pulley fit ok with the stock belt and tensioner?[/QUOT

No, your going to need either a smaller belt or an oversized tensioner pulley.

Platinum_Injected

07-27-2016 08:32 AM

is there a gasket that need to be replaced once taking this off like the valve cover?

Evilfrog

10-10-2016 09:54 PM

Just finished up this install this weekend. I referenced this post a few times. Thanks for putting it together.

ChefordSS

04-29-2018 05:56 PM

Hmm

Kinda amazes me that thats all it is....its just pressed on....i would think the shaft would spin in side the hub or thatsthe hub would just wobble off.

All times are GMT -4. The time now is 02:48 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page