Michigan
This. The wires coming out of the 02 sensor are contacting the heat shield and blowing the fuse. Happened to me a few times.
i had my powell rear bushings put in today. i went to install the a-arms and i had a lot of play in it. i measured the gap the bushing goes in and then the bushing and there is a little over a 1/4" gap. suggestions?
http://www.google.com/imgres?q=cobal...0&tx=151&ty=64
That 02 sensor, tape the wires that come out of it.
That 02 sensor, tape the wires that come out of it.
Red circle correct?



. I put down 251 on zzp's dyno back in march.