Mark this thread as Unsold
For Sale Retro's and Retro's
#1
Retro's and Retro's
Andrew Jagodzinski
Katy, Texas
Pm or 832-656-9498
PRICE CHANGE: $250 plus shipping
What's up CSS, I come before you with some stuff I need to get rid of.
I have a set of mini h1 retro's I built a couple days ago. The projectors are used but everything works. Mini Gatling shrouds painted semi gloss black, tinted ss lens. They are not perfect but not bad at all, light scratches on the lens, a couple tabs broke on each light. I used black butyl from trs, they are sealed with an abundent amount of that stuff and the projectors are epoxed in place. The bottom of the passenger side has a hole in it. It could be repaired with some jb weld and it would be good to go. Idk if they leak but they should not(havent had them on my car but to just aim them), I am selling these AS IS. Looking for $275 plus shipping. They will need those metal paper clip looking things that hold in the bulb and screws for the bulb holders.
Sorry for the long ass post but Im trying to get all the info out about them. They are full of finger prints.. Sorry
Katy, Texas
Pm or 832-656-9498
PRICE CHANGE: $250 plus shipping
What's up CSS, I come before you with some stuff I need to get rid of.
I have a set of mini h1 retro's I built a couple days ago. The projectors are used but everything works. Mini Gatling shrouds painted semi gloss black, tinted ss lens. They are not perfect but not bad at all, light scratches on the lens, a couple tabs broke on each light. I used black butyl from trs, they are sealed with an abundent amount of that stuff and the projectors are epoxed in place. The bottom of the passenger side has a hole in it. It could be repaired with some jb weld and it would be good to go. Idk if they leak but they should not(havent had them on my car but to just aim them), I am selling these AS IS. Looking for $275 plus shipping. They will need those metal paper clip looking things that hold in the bulb and screws for the bulb holders.
Sorry for the long ass post but Im trying to get all the info out about them. They are full of finger prints.. Sorry
Last edited by ampzor350; 02-15-2013 at 08:35 PM.
#19
I believe if you drill a hole in the bottom of the housings it will give the water somewhere to go. I think I heard someone say something along the lines of "you can over seal the lights and they will fog up" not sure if that makes sense
#21
Drill a few holes in the lowest points in the back of the lights it will give the water a place to drain out then reseal. You don't have to take it apart again just do the edges all the way around and you should be good to go.