Mark this thread as Unsold
Wanted WTB: 4-2-1 exhaust header
11-11-2023, 11:48 AM
#1
New Member
Thread Starter
WTB: 4-2-1 exhaust header
Looking for 4-2-1 header for any ecotec, preferably 1-3 2-4.
One with the Tsudo/M2/Manzo design that was made for the Cavalier would be awesome
One with the Tsudo/M2/Manzo design that was made for the Cavalier would be awesome
Last edited by a_monkie; 11-11-2023 at 12:15 PM.
11-13-2023, 07:30 AM
#2
Senior Member
The following users liked this post:
Monieg5gt (11-13-2023)
11-13-2023, 02:47 PM
#4
Senior Member
So are you doing a ecotec lsj swap? I've seen a few done on youtube. You should post up some pics. i've love to see. I'm in the process of supercharging my 2007 Pontiac G5 Gt with the M62 Supercharger from the lsj. Good luck with your project man. I'm a huge lover of fiero's and always wanted to buy one and do a 3800 series swap with the supercharger.
11-13-2023, 05:32 PM
#5
New Member
Thread Starter
Its going to be an LEA swap with an F23 which is the easiest way to get an Ecotec in there because you can use the Fiero's stock axles. Right now i'm beginning the parts gathering phase.
Later down the line may change over to an LKW with an F40 but that would be later down the road and ive got more research to do to get to that point.
You can see some of the engine/trans related research and info for the swap in this thread:
https://www.cobaltss.net/forums/adva...arison-330703/
Later down the line may change over to an LKW with an F40 but that would be later down the road and ive got more research to do to get to that point.
You can see some of the engine/trans related research and info for the swap in this thread:
https://www.cobaltss.net/forums/adva...arison-330703/
Thread
Thread Starter
Forum
Replies
Last Post
