My Hahn Exhaust is Defective...
My Hahn Exhaust is Defective...
I was a part of the Hahn group Buy for the 3in catback. I installed the exhaust about 3 weeks ago and now the exhaust seems to be hollowing out. There is fiberglass or whatever hahn uses for their mufflers all over the back of my car. Just watch the vids, I explain it in there.
Cold start, no problems when cold
http://smg.photobucket.com/albums/v2...t=MVI_0781.flv
Up to operating temp
http://smg.photobucket.com/albums/v2...t=MVI_0782.flv
Cold start, no problems when cold
http://smg.photobucket.com/albums/v2...t=MVI_0781.flv
Up to operating temp
http://smg.photobucket.com/albums/v2...t=MVI_0782.flv
umm no, that does not sound normal from the outside, check your gaskets and get a gasket maker, the copper kind. and it cant be your downpipe or header because you didnt even take them off.
also, at your discretion, hose some water up into the exhaust, NOT A LOT, and put a bucket by the tip and lightly rev it to get that water back out and see what are the contents in your bucket, if theres anything besides dirt/oil/grease like metal or pieces of **** then YOU GOT A BAD CATBACK, most likely the muffler or resonator if you have one
also, at your discretion, hose some water up into the exhaust, NOT A LOT, and put a bucket by the tip and lightly rev it to get that water back out and see what are the contents in your bucket, if theres anything besides dirt/oil/grease like metal or pieces of **** then YOU GOT A BAD CATBACK, most likely the muffler or resonator if you have one
you mean like ZZP? i used to have a defective header that they kept telling me it was my fault for installing wrong or kept telling me to check for exhaust leaks everywhere else on my exhaust and then i gave it to a friend and he went to have his car tuned with my header on it and the tuner found a hole somewhere and of course just like i did my buddy lost 20hp
Im not argueing, i was just asking.
Any clue where the sound is comming from? have you gotten under there and listened? Mufflers are made on an assembley it is quite possible a machine missed a spot weld. Like the others have said, your best bet is to get into contact with Bill on tuesday.


