S/C'd Tiburon Video
Thread Starter
New Member
Joined: 11-06-07
Posts: 100
Likes: 0
From: Connecticut
S/C'd Tiburon Video
Hey Guys,
Many of you remember my posts about my build and dyno so I finally got a chance to take a quick video with a flyby and 20-100.
With the 20-100 the car was parked at the store so it was heat soaked and I had a passenger. Also, it's been mentioned that the accel. appears to be slow in the video. This is because I'm an automatic so I've got long gears and am at the top of 2nd at 80. People are used to judging speed by the time between shifts so I figured I'd just throw that out there since it was discussed on the tiburon forum.
Enjoy
http://www.youtube.com/watch?v=Mg22yJlF8q0
Many of you remember my posts about my build and dyno so I finally got a chance to take a quick video with a flyby and 20-100.
With the 20-100 the car was parked at the store so it was heat soaked and I had a passenger. Also, it's been mentioned that the accel. appears to be slow in the video. This is because I'm an automatic so I've got long gears and am at the top of 2nd at 80. People are used to judging speed by the time between shifts so I figured I'd just throw that out there since it was discussed on the tiburon forum.
Enjoy
http://www.youtube.com/watch?v=Mg22yJlF8q0
Junior Member
Joined: 02-06-07
Posts: 432
Likes: 0
From: Corning, NY
very nice man, my GF just ordered her NGM Sniper kit Iced a couple weeks ago, we will be doing the install and some tuning in the next few weeks. The car has a few other goodies and i'll be doing some s/c tricks on it so we are hoping for somewhere around 250whp 
Thread Starter
New Member
Joined: 11-06-07
Posts: 100
Likes: 0
From: Connecticut
thanks everyone!
Nothing wrong with the trans.. i don't know specifically what's happening but everyone with a supercharged auto experiences the "bouncing"
With the assassin you need a built bottom end... they pop motors
With the assassin you need a built bottom end... they pop motors
Junior Member
Joined: 02-06-07
Posts: 432
Likes: 0
From: Corning, NY
The assasin is completely overkill for the 2.7 unless you do a full build. My bet is the m62 sniper in the right hands can put down some serious hp on a stock block. Ultimately i'm shooting for around 300whp on the GF's tibby and that should more than satisfy her
Thread Starter
New Member
Joined: 11-06-07
Posts: 100
Likes: 0
From: Connecticut
I think a stage 3 sniper makes just about that... I'm going to be swapping in a better cooling system and a 6.5" crank to turn the boost up to 10 psi or so
Thread
Thread Starter
Forum
Replies
Last Post