i know this is a repost but just need to confirm plz
01-13-2012, 05:44 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: 05-04-11
Location: atlanta ga
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
i know this is a repost but just need to confirm plz
Iv got a 2.2l installing a oil pressure gauge elect. Iv heard putting it on the drive side plug on the motor..one of the reps from autometer told me this but iv also heard to put it in one of the plugs infront under the intake mani..just need to confirm this which one.. the one on the driver side someone says.it will give a low pressure reading? But if I do go under the intake mani i need a 90o..so it will be the 90o then the fitting 2278 or adapter on that then tubing to the sender? Haha sorry I'm trying to put this out here because.I'm about to.board my plane
01-13-2012, 08:27 PM
#2
Iv got a 2.2l installing a oil pressure gauge elect. Iv heard putting it on the drive side plug on the motor..one of the reps from autometer told me this but iv also heard to put it in one of the plugs infront under the intake mani..just need to confirm this which one.. the one on the driver side someone says.it will give a low pressure reading? But if I do go under the intake mani i need a 90o..so it will be the 90o then the fitting 2278 or adapter on that then tubing to the sender? Haha sorry I'm trying to put this out here because.I'm about to.board my plane
any galley plug in the block works i believe
Thread
Thread Starter
Forum
Replies
Last Post