Problems/Service/Maintenance Do you have problems with your new 2.0, 2.2, or 2.4L? What kind of service did you have done?

LNF won't start

Old Jun 27, 2014 | 08:36 PM
  #1  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
LNF won't start

My car won't start. Won't turn over. I've checked for bad fuses and tested the battery, both are fine. My windows, radio, headlights, etc all work. When I turn the key on my DIC reads "service power steering" "service traction control" "service esc". Any ideas?
Reply
Old Jun 27, 2014 | 08:50 PM
  #2  
Wert842's Avatar
Senior Member
iTrader: (3)
 
Joined: 07-12-11
Posts: 4,301
Likes: 1
From: PA
Try leaving the car disconnected from the battery for 30 seconds.
Reply
Old Jun 27, 2014 | 09:12 PM
  #3  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
Just went out and tried that, still nothing.
Reply
Old Jun 27, 2014 | 09:19 PM
  #4  
Slowbalt2000's Avatar
Moderator
Platinum Member
Moderator
iTrader: (1)
 
Joined: 05-15-11
Posts: 27,333
Likes: 584
From: Livonia, MI
Hmmm. Maybe try pulling the fuse for esc and traction control and see what happens? Have you had the recall done?
Reply
Old Jun 27, 2014 | 09:21 PM
  #5  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
I'll go back out and try pulling those fuses. I haven't had the recall done.
Reply
Old Jun 27, 2014 | 09:24 PM
  #6  
Tomtwtwtw's Avatar
Senior Member
 
Joined: 03-30-06
Posts: 5,489
Likes: 0
From: Chandler, AZ
Originally Posted by bmartz1991
My car won't start. Won't turn over. I've checked for bad fuses and tested the battery, both are fine. My windows, radio, headlights, etc all work. When I turn the key on my DIC reads "service power steering" "service traction control" "service esc". Any ideas?
Sounds like all the **** it reads while you're reflashing the ECU. Wonder if it took a dump?
Reply
Old Jun 27, 2014 | 09:29 PM
  #7  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
Originally Posted by Tomtwtwtw
Sounds like all the **** it reads while you're reflashing the ECU. Wonder if it took a dump?
That's kind of what I'm thinking.

I did install a HID fog light kit and have only had the car started once since then. I'm wondering if it somehow fried or fucked my ECU up. I had one about a year ago though and didn't have any issues.
Reply
Old Jun 27, 2014 | 09:41 PM
  #8  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
Originally Posted by Slowbalt2000
Hmmm. Maybe try pulling the fuse for esc and traction control and see what happens? Have you had the recall done?
No luck on the fuses.
Reply
Old Jun 27, 2014 | 10:20 PM
  #9  
63 Nova SS's Avatar
Senior Member
iTrader: (3)
 
Joined: 06-12-12
Posts: 5,466
Likes: 316
From: Indiana
sounds like ecu, didn't you get tuned at zzp recently? Shame you cant reload it, and try again.
Reply
Old Jun 27, 2014 | 10:30 PM
  #10  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
Yeah, it's been tuned by ZZP for almost two months now.
Reply
Old Jun 27, 2014 | 11:00 PM
  #11  
user 72239's Avatar
Banned
iTrader: (4)
 
Joined: 01-21-11
Posts: 12,948
Likes: 162
pull your ECU, then reseat it.
Reply
Old Jun 28, 2014 | 06:54 AM
  #12  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
I'll try that, if worst comes worst and I have to replace it I'll have to get the car retuned again, correct?
Reply
Old Jun 28, 2014 | 08:23 AM
  #13  
andrewcarr1993's Avatar
Senior Member
iTrader: (5)
 
Joined: 10-23-12
Posts: 5,095
Likes: 2
From: Clarence, NY
Yes, unfortunately that's the case.

But ZZP would probably work something out with you.
Reply
Old Jun 28, 2014 | 09:16 AM
  #14  
Omiotek's Avatar
Senior Member
iTrader: (2)
 
Joined: 07-04-10
Posts: 3,262
Likes: 66
From: Carol Stream, IL
check the big powersteering fuse. its yellow if i remember correctly. just look for a break between the soder joints. you cant get a test light on it. have you had the fuse box, grounds or power disconnected?
Reply
Old Jun 28, 2014 | 11:15 AM
  #15  
heeter_33's Avatar
Senior Member
 
Joined: 03-23-09
Posts: 3,103
Likes: 130
From: Sask, Canada
Had a rental Ram that was doing the same thing, saying "Sevice ___________ soon." ECU was fried on it. Once it was shut off, it wouldn't start. It was completely dead too.
Reply
Old Jul 1, 2014 | 05:41 PM
  #16  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
Originally Posted by andrewcarr1993
Yes, unfortunately that's the case.

But ZZP would probably work something out with you.
I hope they do too if that's the case.

Originally Posted by Omiotek
check the big powersteering fuse. its yellow if i remember correctly. just look for a break between the soder joints. you cant get a test light on it. have you had the fuse box, grounds or power disconnected?
I did have the grounds under the headlights disconnected to ground the HID fogs, but I checked them.
Reply
Old Jul 1, 2014 | 09:28 PM
  #17  
63 Nova SS's Avatar
Senior Member
iTrader: (3)
 
Joined: 06-12-12
Posts: 5,466
Likes: 316
From: Indiana
did you get it running?
Reply
Old Jul 1, 2014 | 10:22 PM
  #18  
bmartz1991's Avatar
Thread Starter
Where's The Cruze SS?
Platinum Member
iTrader: (35)
 
Joined: 02-04-12
Posts: 9,042
Likes: 7
From: Donegal, PA (Pittsburgh Area)
Nope, got it towed to the stealership today.
Reply
Old Jul 3, 2014 | 07:17 PM
  #19  
redcobaltmadness's Avatar
New Member
 
Joined: 06-26-14
Posts: 11
Likes: 0
From: Greeley Colorado
Originally Posted by bmartz1991
Nope, got it towed to the stealership today.
If all that shows on the dic is mileage and temp, and the radio still works check your wires to your bcm, i took my ls in and it would turn on but it threw a security lock out code, they found shorts along the wires running to my bcm, fixed that and replaced a rew mini fuses and got it back up.
Reply
Old Jul 3, 2014 | 08:05 PM
  #20  
slvrred-'s Avatar
Senior Member
iTrader: (2)
 
Joined: 01-21-08
Posts: 906
Likes: 0
From: Woodstock, NY
Sounds the ign switch to me. You'll get power but nothing will happen when you crank it and you'll get all those messages. They will probably start with the switch and then go from there if that wasn't the problem.
Reply
Old Jul 3, 2014 | 09:32 PM
  #21  
Cobalt_Daddy's Avatar
Senior Member
 
Joined: 08-19-09
Posts: 7,665
Likes: 7
From: Windsor NS
sounds like you should probably sell it and buy my Sedan
Reply
Old Jul 3, 2014 | 10:40 PM
  #22  
cfsnipers's Avatar
Member
 
Joined: 05-15-13
Posts: 336
Likes: 0
From: Ottawa
I had to replace a whole fuse block because it was so badly corroded underneath. All the same symptoms you are describing. It was $700CAD with labour. Vultures!!
Reply
Old Jul 3, 2014 | 11:14 PM
  #23  
Powell Race Parts's Avatar
Former Vendor
iTrader: (3)
 
Joined: 04-25-11
Posts: 6,128
Likes: 47
From: Port Perry
battery. needs to be a full 12 v plus. I bet u ran it down instaling ur HID
Reply
Old Jul 3, 2014 | 11:23 PM
  #24  
footballplaya3k's Avatar
Senior Member
iTrader: (1)
 
Joined: 03-18-12
Posts: 1,750
Likes: 8
From: Vancouver, WA
Have you put a charger on the battery to make sure it's fully charged?
Reply
Old Jul 4, 2014 | 07:55 AM
  #25  
Cobalt_Daddy's Avatar
Senior Member
 
Joined: 08-19-09
Posts: 7,665
Likes: 7
From: Windsor NS
Agreed. Had s problem with my Mazda. Battery read good voltage but no amps. Try a different battery maybe if u haven't already.
Reply

Thread Tools
Search this Thread

All times are GMT -4. The time now is 08:54 PM.