Tuning For tuning and related discussions

After shutting off sensors for codes, car will not shift pass 6000 rpm

Thread Tools
 
Search this Thread
 
Old Aug 12, 2009 | 07:23 PM
  #1  
celicacobalt's Avatar
Thread Starter
Senior Member
 
Joined: 05-26-05
Posts: 6,375
Likes: 0
From: Pittsburgh, PA
Question After shutting off sensors for codes, car will not shift pass 6000 rpm

The car never had a problem with the auto tranny shifting all the way to 6500 rpm. Now after turning off codes that were making the pcm disable the engine the car runs great except for WOT shifting it hits 6k and stops just starts making a burbling sound. Wont shift through it. It is erratic though because sometimes, not all the time it will shift normally if going downhill. It doesnt like going up hill at all and will sometimes shift through on flat but most of the time not. What in the tune would cause this?

On a side note, the shift points were all changed to 5000 rpm shift points and when tested the car just drove and revved all the way up to 8000 rpm. It totally ignored the command. When changed back to 6500 rpm shift points it listened but then started to not wanna go past 6k. Any input?
Reply
Old Aug 14, 2009 | 11:01 AM
  #2  
celicacobalt's Avatar
Thread Starter
Senior Member
 
Joined: 05-26-05
Posts: 6,375
Likes: 0
From: Pittsburgh, PA
No ideas?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turbo Johnny
2.0L LNF Performance Tech
18
Feb 21, 2019 09:41 AM
Meadowvalien
Drivetrain
1
Aug 17, 2017 06:32 PM
Spanky's Monkey
Parts
37
Mar 7, 2016 06:06 PM
Getaway_Driver
08-10 SS Turbocharged General Discussion
25
Sep 5, 2015 09:16 PM
Infamous SC/SS
2.0L LNF Performance Tech
5
Sep 4, 2015 05:33 PM




All times are GMT -4. The time now is 03:12 PM.