Well i did my intake mod n **** well after driving it for a day i got CEL so should i just reset it?

 

bump

 

LMAO you need to bump after 20 minutes. You should find out what the code is first.

 

post the code you are getting and someone should be able to tell you what it is

 

MAF out of range, blah blah blah. Run it for a while, then get it reset. It should stay off.

 

I went to autozone and they said it was runing lean? any suggestions??

 

What brand intake?

Injens and AEMs tend to throw no codes at all. I have a Fujita but only get a code when the filter needs cleaned. K&Ns tend to throw codes a lot.

 

did the intake mod myself, used k&n e-1009, no cel had it on for a month already, through rain and whatnot.

 

Yeah, if you just did the airbox mod, it typically doesn't throw a code unless your filter is loose. If that's what you did, Re4peR26, then check the clamp on the filter and make sure it's on there nice and tight.

 

check the tubing too, all the hose clamps... any air leak after the maf could cause it