[PCM] P0230 - Fuel Pump Relay Control Circuit (Pending) (Current) (Immature)

Since my thread was so general and long
I am making a new one, the car is all done accept this error

The fuel pump primes i hear it buzz/humm it has pushed fuel back into the fuel rail i check the bleed off but the car will not fire


Would anyone happen to know where the fuel pump relay is?

Check your owners manual, it must be in there

nothing in there

[PCM] P0230 - Fuel Pump Relay Control Circuit (Pending) (Current) (Immature)

Since my thread was so general and long
I am making a new one, the car is all done accept this error

The fuel pump primes i hear it buzz/humm it has pushed fuel back into the fuel rail i check the bleed off but the car will not fire


Would anyone happen to know where the fuel pump relay is?


HA HA....I can finally help you for a change!!

Here you go brother! (http://www.eclsja.com/service/dtcfiles/dtcp0230.htm)

BTW....thanks for introducing me to Scott at Cobalt performance parts :twothumbs :cssNET:

you said you replaced all the relays right? and after you replaced them you got this code correct? check to make sure the relay is in properly and the right relay for that matter

No, sorry for not updating replacing the relay fixed this I am cell free my engine wont fire though ....

So im out of leads accept i have no spark

you could test this by going to a good known ground on the block or just touch the ground strap to the block when attepting to fire it

I always use my motor mount as a ground

wrong side of the engine but that would work if the strap was long enough. i meant to post that last post on the other thread but im tanked so i have an excuse