The carbon fiber lip from a hyndai tiburon (iirc). The second coolant resevoir is for the meth kit, and is all ready to go. The side exhaust is actually where my QTP electronic cut out comes out. I built a 3" dp and exhaust (to axle) and reduced it down to use the stock axle back and muff. Quiet when closed (not quite stock outside car..but from inside, can't tell the diff) and hella loud when open full. I used the tog header, and just decked the fanges at work and went over welds. Its seems to be totally fine. Liked how it was a full 3" dp opening.

oh, and the bolt pics are my $1.50 special "zzp tensioner release tool". It can be purchased thru me for $30 I used a 3/4" bolt/nut and it worked well since the zzp adjustable tensioner doesnt have a notch in it..

Enjoy.

 

That lip fits nice or was it a pia to fit it.

 

Was a time consumer to get it bolted on evently and nicely. Working on ur back under the car never helps. But it was worth it imo. I should get off my lazy ass and take some pics of the car outside. Its a subtle lip, but give it just enough of a difference to be like...hey.

 

what 60ft do u get with slicks, and 1/4 mile?

stage 1 with a stock pulley?

 

I have been trying to think of a way to put a lip on the front bumper w/o putting a ground fx kit on. this is good. where did you get the lip?

 

I actually bought it used.

mm.. 1.94 60ft, for a 13.7 1/4mile. Though, i missed the desired map tables, so i'm sure it was bleading off boost in 3rd gear (was on the hwy on the way to the track..didn't realize i missed that in hpt). Didn't log that run doh. Was the first time out with the new car. First 2 runs were just feelers, and 3rd i got a good launch, 3300rpm and didn't rush 3rd gear shift (which i seem to miss when i really try to jam it). Just updated sig, and was using the 2.85 pulley w/gm 42 injectors for now. Still potential for faster times with this pulley/setup, before i go smaller.

Nate

 

looks good, you should make a vid .... must be loud exhaust

any pic of the exhaust while car was on hoist? (in the air)

 

Awesome idea on the Lip.

Do you know if they have those in black for the Tiburon too? Does it come off a stock Tiburon or a special model?

 

How much did you pay for the cutout? And where did you get it

 

http://www.quicktimeperformance.com/QTEC/index.php

 

No idea about info on the hyndai lip. It was an aftermarket one. I bought it off a guy who had a cobalt.

QTP from summit is only 120 for 3" i believe.

Can't find the pics of the exhaust under the car. But its ur standard 3", but i just reduced it to slip over stock exhaust right before the rear axle (cut it at the stock weld seam). And then welded a piece to where it takes the 90* turn to go straight out to the side.

I'll get some up the next time im under the car.
Nate