Which one would be best to illuminate the floor boards of my car? Tubes? If so What size? 6" - 9" - 12"? Or single LEDs?

 

Buy these:
http://www.pctoys.com/840556011057.html

slice off the power plug, leave the switch if u want, and hook them into the fusebox. make sure u tuck them up undearth very well. if u want more of a direct light, try these:

http://www.pctoys.com/840556051619.html

 

dude thanks a lot - do you think 12" is going to be to big or just right?

 

http://www.oznium.com/cathode-kit


you get 1 kit for under 7 bux.

1 kit = 2 12"tubes, and 1 Transformer.

My buddy just bought 4 kits, and I have 2 kits installed on my car

 

just right. installed these plenty of times.

here is my first ever cathode install (ive gotten alot better since then lol, but he wanted them there i swear!):








edit: To the post above me ^^ PCToys is one of the top manufacturer's of Cold Cathodes, probably the best out there. But what he posted will probably work just as well. It's the same kit, 2 cathodes, transformer, wire, etc. And you save .50 with PCToys. Choose which ever comes out the be the cheapest after shipping..PCToys is in California

 

lol thats terrible that would blind you if you drive with them on

 

he didnt drive with them on, it's illegal for any light to emit from your vehicle while you're moving in New York. booo

he was a moron, but he liked them, and it was my first install, so eh. not too bad

if you're wondering about the Tri-Razor LED's. here's an old pic of it inside a computer. you can see the light emitting from the bottom onto the table: