So I went to my local Performance shop where a buddy of mine works to get my stock base numbers

The car is 1 month old with just over 2500 miles on the odometer. Bare bones stock right form the factory floor. I was told when I got there that the Dyno is very conservative and can read low... but i just wanted a starting point to see my progression as mods are added.

3 Pulls and we got 227 WHP and 224 WTQ. All were very consistent with each other and barely changed any more than 2 HP and TQ. The AFR starts off pretty lean in these cars and then gets really rich. Can't wait to get a down pipe and tune which is next on my list. That should hold me over until next spring/summer where I will add something else....

So here are some pics of what I ran and a little video that i made. Enjoy!

 

nice dude... i think they fucked mine up. all i have is a catback and a K&N drop in. no tune.
WITH corections it was like 283 whp and 291wtq...
it was on a mustang dyno also.

 

Nice and persistent, mine made almost identical numbers on a similar powerdyne mustang dyno. Now get some mods done and redyno.

 

nice numbers where are you in Ma?

 

never mind i googled it in leomenster... i used to work out there

 

Yeah, the shop is on the Sterling/Leominster Line. I am from Worcester.

Where did you work out there?

 

Black looks so damn good when it's clean!

 

i work for the commuter rail, when i was out of north station i did alot of runs to fitchburg... it went through there right at 495

 

mustang dynos always read low

just make sure to use that same dyno with any mods and you will see what actaul hp you picked up

 

which is sometimes a good thing so if we get a decent number... we know its atually more then that haha.
too bad its not on the money though...

 

I plan to use this dyno after every mod and tune.

And I ALWAYS keep her clean.

 

Keep at it. SMG motoring is near you and does custom tunes. They are in Hopedale I think. I saw a bone stock lnf go there and gain 60whp out of a tune.

I worked in Sterling /leominster on the line on the powerlines for a while. The job right now is in Greenfield but we are wroking our way back towards worcester then to leominster.

/end threadjack

 

that seems really low compared to some other stock dynos I have seen..

 

Mustang Dyno's seem to run low.

And I was told this particular one reads especially low. I was told I'm probably closer to 235.

 

Hope your comming out with us all tonight!

 

Sadly, I don't think I am...

 

nice numbers, I have a DynoDynamics near me and our number are nearly identical. I agree , stay with the same dyno for your modding, that is the only way to get consistancy. Dynos are just tools , not prooving grounds.

 

If all other manufacturer's read "low" (Mustang, dyno dynamics, Dynomite) and similar. Makes one wonder if it's "actually more".

 

WTF?? I thought we were about 240whp stock??

 

Not on a properly calibrated mustang dyno.

 

Nor Dynomite.
Stock whp is about 210 for the kappa and 225 for the fwd chassis on mine.

 

Term? how did yours make 253whp stock?