what is the minimum requirements with a supa charger.

 

A shitload of nitrous and a built bottom end

 

new engine, basically

 

head work, bottom work, bolt ons to the ****, nitrious to the ****, rwd conversion and ur golden

 

going big turbo.., getting new axles, new clutch, transmisson probly wouldnt hurt, built bottom and top end, big fmic, nitrous and water meth, full 3 inch exhust.. idk alot lol

or get the twinscrew supercarger.. and lots of nitrous and meth and built engine and axels and slicks and a jet engine

 

Just get like Four 20lb bottles of nitrous and run a 400 progressive shot and you're golden

Make sure you get some stage 9 axles and some beast drag radials lol

 

rod's car (tho its a twin turbo)

 

uhh no..
just drag radials and driver mod 4.0

 

zr1?

 

a lot of work, doesnt sound like it will be a daily driver too

 

zr1 still sounds good... 10sec supercharged

 

thats a sweet car, z06 doesnt interest me now

 

Below is a list of everything you will need.

 

Lmao great pic

 

Rofl Rofl Rofl Rofl ^^^^^^^^^^ Rofl Rofl

 

I say 600hp and slicks. however you get that 600 hp is up to you.

 

drop it off a cliff ?

 

Fully built engine, hole cut in hood, and a 671 blower should about do it. You will need to give up your arm, a leg, and most likely one of your ********* for the down payment to start the work.

 

I think you could do it for just your left nut and good blow job.....j/k

I think it is possible without an extreme amount of money, but I predict **** breaking!! for some reason I am trying to picture a cobalt at the tree ready to go and on green I dont see it going anywhere. I just see breakage and broken dreams.

buy a RWD with a V8, doesn't even have to be a big V8.

Or call crate engine depot about there ZZ 572 (720hp) and there Cobalt conversion kit. If you have a spoiler on it make sure you have your pilots license though.