+2.5mm Intake/Exhaust LSJ Valve Upgrade
#1
+2.5mm Intake/Exhaust LSJ Valve Upgrade
In an attempt to make over 500whp on the TVS 1320 Supercharger.
Goal is to be around 15-16 PSI or less.
Pairing this with a forged 2.4 bottom end.
Head is already ported in addition to having ZZP Stage 3 cams + Supertech #75 springs/retainers
Stock Intake Valve
35.17 mm
Aftermarket Intake Valve
36.49 mm + 1 mm Undercut stem
Stock Exhaust Valve
30.12 mm
Aftermarket Exhaust Valve
32.00 mm + .5 mm undercut stem
Test fitting in junk head
Goal is to be around 15-16 PSI or less.
Pairing this with a forged 2.4 bottom end.
Head is already ported in addition to having ZZP Stage 3 cams + Supertech #75 springs/retainers
Stock Intake Valve
35.17 mm
Aftermarket Intake Valve
36.49 mm + 1 mm Undercut stem
Stock Exhaust Valve
30.12 mm
Aftermarket Exhaust Valve
32.00 mm + .5 mm undercut stem
Test fitting in junk head
Last edited by 100% METH; 06-28-2017 at 05:12 PM.
#5
"In short, valve seats are seats for intake and exhaust valves. Since they are in contact with the valve, the airtightness of the combustion chamber is maintained."
The following users liked this post:
100% METH (07-06-2017)