smp4488

So im getting a 2.8 pulley, 60#'s, stage 2 belt and all that jazz. My stupid question is after this is all installed is there any way to drive it to be tuned at all? I dont want to pay the shop to put it all on but i don't want to screw up my car.

REIGN SS

How far away is the shop?

beercan

I would highly reccomend that you dont drive it like that. You could always get to the shop a bit early and put it together.

Deathscythe

it really isn't smart to drive down to a shop with that setup. Too many things could go wrong with a much smaller pulley than stock and higher capacity fuel injectors.

KillerBee

or you can pay a tow truck to tow it for like 50 or 60 bucks

BLAZIN07SS

iTrader: (7)

Aaa Ftw

smp4488

Do you all think AAA would tow it? it is only about 20 miles or and i can stay off the highway.

BLAZIN07SS

iTrader: (7)

AAA will tow it, but usually after 5 miles, it is 8 dollars a mile so $120. do you have a friend with a truck? U-haul rents trailer dolly's for $30 and you could tow it there yourself

Area47

the injectors take all of 5 mins to change.

tREBs

^^^ and about 20 mins for the pulley and belt....

Super_SS

or if u have farmers insurance,the tow is free anywhere as long as its in ur state

idunn

read this again

Mattman6

this thread is funny, just drive there and then install it lol

smp4488

I would do it there but you know how there is always one tool you need that you always seem to forget.

AjSS

If you dont already have a hub on there, it will not be easy to change the pully there. And im guessing by you getting a stage 2 belt, that you still have the stock pully. Pully puller FTL