So im getting a 2.8 pulley, 60#'s, stage 2 belt and all that jazz. My stupid question is after this is all installed is there any way to drive it to be tuned at all? I dont want to pay the shop to put it all on but i don't want to screw up my car.

 

How far away is the shop?

 

I would highly reccomend that you dont drive it like that. You could always get to the shop a bit early and put it together.

 

it really isn't smart to drive down to a shop with that setup. Too many things could go wrong with a much smaller pulley than stock and higher capacity fuel injectors.

 

or you can pay a tow truck to tow it for like 50 or 60 bucks

 

Aaa Ftw

 

Do you all think AAA would tow it? it is only about 20 miles or and i can stay off the highway.

 

AAA will tow it, but usually after 5 miles, it is 8 dollars a mile so $120. do you have a friend with a truck? U-haul rents trailer dolly's for $30 and you could tow it there yourself

 

the injectors take all of 5 mins to change.

 

^^^ and about 20 mins for the pulley and belt....

 

or if u have farmers insurance,the tow is free anywhere as long as its in ur state

 

read this again

 

this thread is funny, just drive there and then install it lol

 

I would do it there but you know how there is always one tool you need that you always seem to forget.

 

If you dont already have a hub on there, it will not be easy to change the pully there. And im guessing by you getting a stage 2 belt, that you still have the stock pully. Pully puller FTL