me and my dad did this with no cuttin and it doesnt hang below the lip either ... we made our on custom brackets tell me what ya think

in this pic you can see our brackets





all done and ready for the front bumper

 

its crooked

 

i rather it be crooked than cuttin my metal on my car

 

you sure that doesn't hang below the bumper? That's about where mine was and it hung below until i cut the bumper support.

 

quick question...do you connect that nipple on the cap filler neck to anything? what exactly is that for??

 

^ You plug it.

 

Mine isn't crooked and I never cut a single piece of metal...

Will post pics tomorrow

 

thanks!!

 

It looks to me like it is about 2-2.5" inches higher than the airdam on the bottom.... uh, last time I checked that is lower than the lip on the front facia! IT IS GOING TO SHOW FROM THE BOTTOM!

 

one more question...does it come with the extra hoses??

 

No go to any autoparts store and buy 3/4" heater hose!

 

I bought one and it does not have any brackets or hoses that come with it.

 

thanks for all the info guys...this will be my next mod for sure...

 

Anyone know which side is the in and which is out? I assume the side with the fill cap is in and the side with the drain plug is the end.

 

That's definitely going to hang below the front lip.

 

QFT, that was exactly how mine was until i cut the bumper support. Check my picture thread and you'll see where it hangs.

 

dont matter.

 

So I was thinkin about when I put mine in, what if I ran it through the coolant resivior into the new h/e back into the manifold. You think that would work out the same?

 

i dont see that doing anything but costing you more for hose...

 

What did you all plug the nipple at the top with?

 

But my question is will it work? I have plenty of hose to do that I was just wondering.

 

It will fuction, yes. It won't do anything useful.


In for pics of car with the bumper back on.

 

How wont it do anything useful? its doing the same exact thing as the other way to run it is.

 

Right, its more work for no useful gain. It will work just the same, no better or worse, and you will have a dozen more clamps to leak, places to pinch the hose, and a lot more time spent. There are other ways to kill time that actually benefit the car.

 

looks good. i did a how to on this. waiting for mod to approve.. how long does that take anyways? its been a day.

cx ftw