I know you need the MT-2 tool to remove the bolts, but I was wondering if anybody has ever just drilled them out and replaced them with some Allen headed type bolts, and if so what size.

I am just trying to figure out what the most economical route is for doing this. It would cost around 15 bucks to get the tool, where as new bolts would only cost a couple of bucks. If anybody has gone this route, what size do I need?

 

bump I know ottp sells them, just trying to see if they can be found at ace or lowes or any of those stores.

 

just buy the tool!!! hate for you to destroy the threads on the hubb bc you couldnt wait. If you paypal me 5 dollers i will send you the tool since I dont run the gm bolts anymore and when someone else is in need of the tool please offer the same deal to them.