Power source for gauges?
#3
Senior Member
iTrader: (7)
I've tapped into the power wire for my stock boost gauge. I've also used an "add a fuse" circuit on the ignition fuse to wire up another members wideband. There's also a fuse panel inside the cabin by the passengers feet on the left, but haven't taken a look to see what fuse you can tap into. Didn't know that was there until recently or I would've used the add a fuse somewhere on that panel.
#4
New Member
Join Date: 09-03-08
Location: Pennsylvania
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
I had my fuse box apart, and used one of the unused fuse slots and ran a wire from there, then branched it out to each of my gauges...but an "add a fuse" would work great too. I used an add a fuse to hook up my IC pump off an ignition sourced device (I think I tapped into the fuel pump fuse). Lots of options if you use an add a fuse, just pick something that's key on/ignition and you'll be good.
Thread
Thread Starter
Forum
Replies
Last Post