Hey guys, I just got my raptor shiftlight, and made a custom mount for it... will post pictures later, as im sure someone is going to want one of these, anyway, where is the best place to run the lead, or signal wire to? I got the power and ground figured out, just need to know where the signal wire goes, also, what setting on the sheet for the cylinder thing? like what position should the 3 little switches be in? Let me know asap, as im wiring it tommorow...... thanks a lot boys, Tommy

 

Check the raptor site man it gives you all the info in the install section.
I love mine.

Later

 

i looked, and our car isnt even listed..... where did you run yours?

 

run it to the brown and white wire on the #1(it is the one on the pasanger side) coil also it comes set to the singel cylinder seting all i had to do was wire it and set the rpm,s

 

From the raptor web site.
2005: tach signal is at cylinder #1 ignition coil, brown wire with white stripe (ignition coil driver #1 from PCM)

http://www.raptorperformance.com/Chevrolet/cobalt.htm

Later

 

let's see some pictures, my raptor is coming next week.

 

any pics of them yet?