Little question about Header/DP.....
#1
Senior Member
Thread Starter
Join Date: 05-19-06
Location: Minnesota
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
Little question about Header/DP.....
I already have PMed Donna about this but I know she's busy so maybe someone could help me out.
I have the GMPP Performance Cat-back. I'm looking to complete my performance for being N/A (without internals). I know the Header will work that they (they being CA.com) got.
My question is as follows: Since I have the GMPP Performance CB should I get the 2.5" or the 3" DP/Hi-flow cat?
Also does the Header bolt up to the DP?
Thanks for you help.
I have the GMPP Performance Cat-back. I'm looking to complete my performance for being N/A (without internals). I know the Header will work that they (they being CA.com) got.
My question is as follows: Since I have the GMPP Performance CB should I get the 2.5" or the 3" DP/Hi-flow cat?
Also does the Header bolt up to the DP?
Thanks for you help.
#2
Senior Member
Thread Starter
Join Date: 05-19-06
Location: Minnesota
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
These are a factory replacement so no welding or cutting is necessary. Will bolt right up to factory header, and most aftermarket shorty headers.
Taken right from their site. I need to read better/closer. NVM thsi topic! <--- don't because I still need to figure out if I need the 2.5" or 3" DP!!!!!
Taken right from their site. I need to read better/closer. NVM thsi topic! <--- don't because I still need to figure out if I need the 2.5" or 3" DP!!!!!
#7
Senior Member
Thread Starter
Join Date: 05-19-06
Location: Minnesota
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
Gracias fellow balt owners.
Now I just need to wait until next year to get them. I will be getting a TWM Short throw for a christmas present. From: Me. To: Me!!!
Now I just need to wait until next year to get them. I will be getting a TWM Short throw for a christmas present. From: Me. To: Me!!!
Thread
Thread Starter
Forum
Replies
Last Post