Oh my, look at how big you are...
pretty much
btw you never called back!
you have to chase after your dogs?
ill see what i can do about getting you one these blowers. im sure jr wouldn't mind making a plate now that he's done it a few times w/ the mill.
wait until i go back to the same dyno I recently dynoed the m62 2.7 setup on for a direct comparisson.
btw you never called back!
you have to chase after your dogs?
ill see what i can do about getting you one these blowers. im sure jr wouldn't mind making a plate now that he's done it a few times w/ the mill.
wait until i go back to the same dyno I recently dynoed the m62 2.7 setup on for a direct comparisson.
But my sisters dogs on the other hand... they are good for NOTHING. one i have to take to the pound, its aggressive and bit @ the baby (german shephard, not pitbull) and it gets out all the time.
she got it from the pound, its wild. its gotta go back lol we gave it way more than 1 chance.
Hey Steve, Jimmys Cobra with the Vortech/Lysholm 3.3 16* of timing, 16psi, 5" cai with the Vortech billet 123mm maf put down 595rwhp 505rwtq lol That was on 91 octane btw
Last edited by euthanasia; Nov 19, 2010 at 12:31 AM.
I was gonna start moving forward on the centri kit when Jimmy said that Vortech is going to start making the 1600 ax in house. He asked if I would rather do that? I said hell yeah lol. He said it should take Vortech about 2-3 weeks to re tool and start making them.
Junior, how's it been man?
Thread Starter
Senior Member
iTrader: (1)
Joined: 07-02-05
Posts: 8,725
Likes: 2
From: West Carrollton (Dayton), OH
Dick
I never did reply to you pm about the mill... my bad dude. Keep it going man, like I said, I'm interested in the end result
I never did reply to you pm about the mill... my bad dude. Keep it going man, like I said, I'm interested in the end result
Last edited by WickedSS2005; Nov 20, 2010 at 03:23 PM. Reason: Automerged Doublepost
