u sure ur on the right forum bro? u might be lost... this is cobaltss.net home of the cheap ass ****

 

^couldnt say it better

 

 

I kind of agree, I think $150-200 a pair is fair, and thats ONLY if they bolt into car like stock, I can't tell from pictures but it looks almost like they bolt in to floor in front. To me that's unacceptable if they are $300-400 a pair......

 

the bolt is in the back the front looks like the stock slider bullshit no?

 

the corbeau rails are just like stock and are only 92$ shipped

 

I'm not 100% sure why you find that so hysterical. Personally $75 a side is a perfectly fair price. Especially since you can find ready made seat brackets for less then that and I have a local shop that can make them for $115 per side. Somewhere in the price range of $75 per bracket is fair on a group buy price in my opinion.

 

Check out the specs of the R100's and compare to other seats that you like.

http://www.sparcousa.com/resourceFiles/26.pdf

 

put differnt sliders on stock rails and see how high the seat will sit, there is a reason the price is a little higher, these rail/slider combo will keep the seat from sitting hella high. yes 200$ is a tad bit high i wouldnt even pay that for them but 80-100 would be a good price range. and yes i had aftermarket sliders on stock rails and it wasnt that great and sat very high

 

Could have sworn I read $75.00 for both sides. My bad

 

I am bringing seat brackets to market that permit both stock belts and 5 point harness. 200 the pair. will be available in June at CED....fit sparco seats, no reason they wont fit momo etc. The anchor on the center of the car moves with the seat slider like stock.

 

 

Pencil me in for a pair John.