so can or has anybody figured out how to wire up the tail lights and reverse lights so that both left blink on a left turn and both right blink on a right turn...essentially has ne 1 figured out how to make corvette tail lights out of our balt ones

 

Not unless you install LEDs or something into the inner lights. Or buy these ones, they're pre wired and everything.
Cobalt Addiction has five different designs.
www.cobalt-addiction.com




PS: The LED CHMSL is from a GB from ModernCEO.

 

hideous...

 

i installed leds in the reverse lights and tapped them in to the brake light harness.just use a volt meter and see what wires what its not too hard at all and look fantastic in the stockers

 

Then get the stock looking ones. Or the stock smoked/tinted ones. I didn't tell you to buy the same ones i have.

 

i have these...

 

Them's the same ones I have, and IMO they look a million times better than those other lights. They have five different designs, yes, but all five look like hell to me. These look like they came on the car from the factory.

 

i think i saw a how to on this.. but maybe it was for skyline lights not to sure

 

Man, if you figure it out, you need to write a How to for us.......Very interested

Jay B

 

Well, the only way to really do it like Corvette tails would be to completely remove the reverse light functionality. The smart way to do it is to put LEDs in the red section of the reverse light housing.

 

I WAS GONNA BUY THE BERMUDA BLACK VERSIONS OF THOSE...BUT EVEN SO....DO BOTH INNER AND OUTER LIGHTS BLINK ON TURNS OR DO YOU JUST HAVE TO FIGURE A WAY TO DO THAT SEPARATELY AFTER YOU INSTALL THEM??

 

They come wired up to do exactly what happened in the video. One wire between each outer and inner tail, and they are male/female connections. It doesn't get any easier.

 

thanx man...i was already plannin on gettin a pair so its good to know that i wont have to do any wiring