Dyno tuned at ZZP
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: 08-30-12
Location: Michigan
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
Dyno tuned at ZZP
So I finally got around to going to ZZP after installing my stage 2 kit and 1.0 PCM and Turbo Tim dialed my tune in for me and gave me a dyno sheet. Without corrections (not shown on sheet) I was making 268whp and 242wtq on a 30 degree day. With corrections and whatnot, I'm making 252whp and 219 wtq. My mods are 3.0" pulley, 60# injectors, 1 step colder plugs, zzp midlength headers and 2.5" dp with high flow cat, 2.5" Tsudo exhaust (loud as hell in the dyno room!), and stock airbox mod. Plus, I'm running my stock heat exchanger and my ic pump isn't working (found that out at ZZP).
https://www.cobaltss.net/forums/memb...fotf8ef-15056/
https://www.cobaltss.net/forums/memb...227-003-15055/
https://www.cobaltss.net/forums/memb...227-002-15054/
https://www.cobaltss.net/forums/memb...fotf8ef-15056/
https://www.cobaltss.net/forums/memb...227-003-15055/
https://www.cobaltss.net/forums/memb...227-002-15054/
Last edited by mahfouzman; 02-27-2013 at 01:22 PM.
#3
Senior Member
Thread Starter
iTrader: (1)
Join Date: 08-30-12
Location: Michigan
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
Haha I put the link instead, and thanks man I'm really not sure lol, but the pump wasn't working from the beginning, Tim told me my IAT2s are 55 degrees higher than my IATs, terrible. Maybe the cold weather helped?
Thread
Thread Starter
Forum
Replies
Last Post