ok i know theres one in the DIY section but the wire i got from plasmaglow does not run all the way from the back of the car to the hood. suggestions?

i kno its not the best pic
paint 4tw.

http://img223.imageshack.us/my.php?i...3269071xr3.jpg

 

...phail!

 

ha!!

 

how do u join social ecotecs

 

get some wire and some connectors, strip the ends, put them in the connectors and pinch them.

or you can buy a wire stretcher for like $30 at autozone or home depot.

 

how about where to run them?
i dont wanna cynge a wire while driving
or pinch em

umm social? i dont know
socal is kali =p

 

i ran mine right up along the brake and fuel lines on the driver side

 

You jsut get some wire and connect it and run it like mentioned above along the fuel lines.

 

just get a bag of small zip ties and zip it up the fuel lines all the way up into the engine bay, the sides you can run them over on an angle then up the passenger I ran up and along with the washer fluid line under the hood the driver side i ran over to the fuel line with the one from the rear and ran them both up together, another option on the sides is to take off the front wheels and fender wells and run them up through there into the engine bay.

 

ok thank you ^_^

 

how about sodering it like you are suppose to, but if you can get some butt connectors that have heat shrink on each end so atleast its weathertight.

 

i have rubber tape =p
n electric tape
handy
and i dont think water will mess up 12v
that bad
duct tape will fix it

 

water will mess up anything. voltage doesnt matter.

 

www.longerwires.com has some you can buy

 

You dont have to take the tire or the fender well off to run the wire behind the fender well. There is alittle hole that you can run it to.

 

Oh God! That **** Is Hilarious!!!

 

do i need a clothes hanger to run it or i can just feed it through w/o?