was thinkin of add some gauges but how hard is it to wire in a battery gauge, a oil pressure should be easy just add a T connection to the dumbie fitting. but forget exhuast cuz i don't want to weld a bung to my stock manifold. any other ideas? ita a 07 2.2 auto. oh and waht size is the SS/SC gauge??

 

Omfg>>>

 

This is well documented on the site. Try searching through the How-to section.

 

ive look and havnt found much. and yah yah laugh it up

 

I want to say 52mm. Someone correct me if i am wrong.

 

thanks bro. cuz if i only do one gauge im goin order the factory pillar, just don't want to order and find out the gauge i want wont fit in

 

factory gauge is 2 1/16. Volt gauge is simple, Run GND wire to a Bolt under your dash and the 12v wire to the + terminal under the hood. Oil pressure, get electric and you can remove a bolt on teh side of the engine and install sender there.

 

dude its not to hard to shave it down with some sand papper and make it fit it still looks great i did it for my aem wideband looks sharp but if you stick to 52mm like buddy said your good to go.

 

Clock, barometer and a compass!!!

 

If you are looking for a stock a-pillar i have one that i would sell since i dont need it... However is does not have the boost gauge.

 

don't need a boost gauge, haha rockin the 2.2 what color is it??

 

My bad on the boost gauge. The od is stock color so tan? Least thats what color i call it

 

how much for that pillar

 

pm me