As The Subject says..

Was wondering the exact parts i would need to make my own cat back, or even rear axle back..

each peice on the Magnaflow Cat-Back is taken from their already made stock and just welded together with some exhaust piping


my questions are does anyone know what the part number on the muffler, the exhaust tip, probrably go with one of their hi-flow cats as well..

but i am unsure about spending between 800-1000 canadian (which is like 100american) j/k

want the nice sound just not the expensive price....

 

I looked on their website and didn't see any mufflers just full exhaust but the only bend in out stock exhaust is 2.5 mandrel bent so you could get an exhaust shop to cut out the bend and weld it to some stainless 2.5 in piping and throw on a muffler. I used the stock exhaust tip and got them to cut out the bend and I paid 196

 

the thing is i can do my own welding, i just dont want a muffler that is loud....

i used to drive a 91 civic si, and i took the fart can from that and tried it on my Cobalt SS/SC. "hell's no to that idea"
thank god i didnt have to buy the muffler, waste of time.......


but im looking for a muffler with a deep tone, as close to the one they use on the cat back systems...

 

I have a question? will exhaust tip fit on a 2.5 inch exhaust.



heres a link to the site.

http://www.crateenginedepot.com/stor...P1380C144.aspx

 

it should since it says it works with gmpp exhaust and it's 2.5 in. Kinda pricey for an ehxaust tip though.