How to Guide For step by step “How to” instructions ONLY!

Appearance: Make a Nice Affordable Lip

Old Dec 18, 2007 | 06:08 AM
  #1  
Eric304's Avatar
Thread Starter
New Member
 
Joined: 01-13-06
Posts: 109
Likes: 0
From: Moreno Valley, CA
Make a Nice Affordable Lip

Well, It's the Home Depot $10 dollar lip. I think it looks decent for the cost, plus you don't have to worry about cracking/scratching it. Everyone who see's my car loves it.

If you guys wanna try it out and see how you like it, then here's the instructions on how to put it on. Only thing is, in the directions, they say to nail or screw it in, and I didn't do that cause the 3M Heavy Duty Double Side Stick tape works well.


Here is the How To

Step 1:
Go to Home Depot!


Step 2: Get Garage Door Bottom Seal, i think they come in 9 ft packs, one will be enough, 2 if u think u will mess up (part #03749)(also notice that there is a foam type and a hard rubber type, i prefer the foam) and a two sided double stick tape that is preferably black, lots of tape, lol (less is seen when black)



Step 3: Place Double stick tape On smaller edge of weather striping.


Step 4: Clean bottom surface of bumper to apply lip. The take off top cover on tape to prepare it to stick on bumper. When putting the lip around the bumper, make sure it sits flush, some like it back more, but i like it flush. Go slow and make sure to get the tape to stick evenly, any extra weather stripping, just cut off flush at the end of the bumper:




Step 5 (optional): I put screws in mine just for saftey, but its not needed, but i suggest it. Put a small screw vary on size depending on person along bottom edge on lip into bumper. I used some washers so it had more area on the lip. Make sure to put the screws back far enough that you wont put a screw out the front of the bumper. I put one about every 4-5 inches.




And Here is the Finished Product of the GDBS LIP (Garage Door Bottom Seal LIP) LOL









Close-Ups








ENJOY!



Will Update This Thread With More Pics if Requested

Last edited by TommyP; Oct 3, 2012 at 12:49 PM.
Reply
Old Jun 27, 2008 | 01:54 PM
  #2  
2.2AVC's Avatar
Member
 
Joined: 05-05-08
Posts: 239
Likes: 0
From: Stroudsburg, PA
did anybody ever do this?
Reply
Old Jun 27, 2008 | 01:56 PM
  #3  
M-Dub's Avatar
Senior Member
 
Joined: 12-19-05
Posts: 9,704
Likes: 0
From: Raleigh, NC
::shakeshead::

You have got to be kidding me.... well it's your car if you want garage door seal on your car then go ahead!

I'll be the guy shaking his head as you drive by!
Reply
Old Jun 27, 2008 | 01:57 PM
  #4  
chris88z24's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 14,142
Likes: 71
From: NY
I think it only looks good on black cars. It's too small of a lip, IMO.
Reply
Old Jun 27, 2008 | 01:57 PM
  #5  
eurochevy's Avatar
Senior Member
 
Joined: 10-14-06
Posts: 3,623
Likes: 1
From: Vancouver, BC
thats gotta be the most ghetto lip i've ever seen in my life + 1 rep for creativeness
Reply
Old Jun 27, 2008 | 01:59 PM
  #6  
springerdesigner's Avatar
Senior Member
iTrader: (1)
 
Joined: 01-24-08
Posts: 2,236
Likes: 0
From: Kansas City, MO
Reply
Old Jun 27, 2008 | 02:03 PM
  #7  
Steven Flit's Avatar
Banned
 
Joined: 06-04-07
Posts: 2,530
Likes: 1
From: Los Angeles, CA
Nice job on a clean install

guys/girls,

this is nothing new... many SRT4s and my buddies Redline have this little mod.
Reply
Old Jun 27, 2008 | 02:05 PM
  #8  
ls1fbody's Avatar
Haz l33t wheelz.
 
Joined: 09-14-07
Posts: 18,883
Likes: 3
From: Costa Mesa CA
wow, i saw $10 home depot and i cold a shiver down my spine. but seeing that you followed the body lines, this looks good. if i didn't know it was garage door flange, i'd ask what vendor, haha
Reply
Old Jun 27, 2008 | 02:08 PM
  #9  
eurochevy's Avatar
Senior Member
 
Joined: 10-14-06
Posts: 3,623
Likes: 1
From: Vancouver, BC
i wonder what happens when ppl start driving like 120km/h or something and dirt and stuff gets into the glue and starts to peel away or something..that would be pretty bad
Reply
Old Jun 27, 2008 | 02:08 PM
  #10  
Pully Police's Avatar
Senior Member
 
Joined: 02-05-06
Posts: 727
Likes: 0
From: Kakabeka Falls, Ontario
*I cant believe I am saying this...*

But that actually looks good...
Reply
Old Jun 27, 2008 | 02:10 PM
  #11  
M-Dub's Avatar
Senior Member
 
Joined: 12-19-05
Posts: 9,704
Likes: 0
From: Raleigh, NC
Wait a little over a year and it starts to brown and get brittle ( I work at Home Depot... and we don't even sell that **** for garage door seals anymore! )


eh not my car
Reply
Old Jun 27, 2008 | 02:14 PM
  #12  
Steven Flit's Avatar
Banned
 
Joined: 06-04-07
Posts: 2,530
Likes: 1
From: Los Angeles, CA
Originally Posted by M-Dub
Wait a little over a year and it starts to brown and get brittle ( I work at Home Depot... and we don't even sell that **** for garage door seals anymore! )


eh not my car
Use the right "product" on it and that shouldn't happen
Reply
Old Jun 28, 2008 | 08:53 AM
  #13  
2.2AVC's Avatar
Member
 
Joined: 05-05-08
Posts: 239
Likes: 0
From: Stroudsburg, PA
i like how no one ever commented this in a year and now theres 12 posts lol
Reply
Old Jun 28, 2008 | 09:11 AM
  #14  
originaladrian's Avatar
Senior Member
 
Joined: 01-22-06
Posts: 8,396
Likes: 0
From: S.FL
that..... is not the worst thing in the world.... still wouldnt do it to my car... but not bad...
Reply
Old Jun 28, 2008 | 02:55 PM
  #15  
dasudevil's Avatar
New Member
 
Joined: 05-29-08
Posts: 107
Likes: 0
From: Gilbert, Val Vista Lakes (ish)
wish my work did not block pictures. Going to BLACKBERRY to see whats up!!!
Reply
Old Jun 28, 2008 | 03:06 PM
  #16  
javit24's Avatar
Member
 
Joined: 12-05-06
Posts: 222
Likes: 0
From: Arizona
looks alright i guess... wouldnt do it to my car
Reply
Old Jun 28, 2008 | 03:11 PM
  #17  
aveoturbo's Avatar
Senior Member
 
Joined: 01-31-08
Posts: 695
Likes: 0
From: chi-town
Originally Posted by Steven Flit
Use the right "product" on it and that shouldn't happen
whats the right product?

it looks aight, i may consider it for my car until i get my FG one made.
Reply
Old Jun 28, 2008 | 07:30 PM
  #18  
2.2AVC's Avatar
Member
 
Joined: 05-05-08
Posts: 239
Likes: 0
From: Stroudsburg, PA
I might do this, cant look any worse than my scratches on the bottom from bottoming out
Reply
Old Jun 28, 2008 | 07:38 PM
  #19  
black_haze's Avatar
Banned
 
Joined: 06-27-08
Posts: 69
Likes: 0
From: Sullivan WI
i bet if you slammed ur car to the ground with that rubber lip, it would be the first car that you could use as a squeegy. (sp?)
Reply
Old Jun 28, 2008 | 07:40 PM
  #20  
Perfect.disguise's Avatar
Senior Member
 
Joined: 04-20-08
Posts: 6,780
Likes: 0
From: .
Like how it changed your car from a yellow SS/SC to a white SS..
Reply
Old Jun 28, 2008 | 07:42 PM
  #21  
chevy cobalt 08's Avatar
Banned
 
Joined: 02-23-08
Posts: 5,881
Likes: 1
From: SI,NYC
Originally Posted by eurochevy
thats gotta be the most ghetto lip i've ever seen in my life + 1 rep for creativeness
+1 too ghetto for me... maybe if it was painted white MAYBE
Reply
Old Jun 28, 2008 | 07:47 PM
  #22  
Black07SS's Avatar
Senior Member
 
Joined: 09-04-07
Posts: 884
Likes: 0
From: Regina, Saskatchewan
Originally Posted by Perfect.disguise
Like how it changed your car from a yellow SS/SC to a white SS..
i was wondering about that too. also, OP what springs are you dropped on?

edit: nevermind i read your sig
Reply
Old Jun 29, 2008 | 01:28 AM
  #23  
Eric304's Avatar
Thread Starter
New Member
 
Joined: 01-13-06
Posts: 109
Likes: 0
From: Moreno Valley, CA
haha... the lip actually looked pretty good!!! No one could tell what it really was untill I told em. But, it is a cheap and easy mod that does give your car a different look!! Plus, it was only temporary untill i got my SS/SC front lip.
Reply
Old Jun 29, 2008 | 01:34 AM
  #24  
dragonslayer27's Avatar
Senior Member
 
Joined: 11-27-06
Posts: 1,331
Likes: 0
From: Laredo, Tx
you know you installed it clean enough for it to look okay. but i would never tell anyone what it really was. i'd always be changing the subject I'm glad it wasn't a permanent mod.
Reply
Old Jun 29, 2008 | 01:35 AM
  #25  
PinaSS's Avatar
Senior Member
 
Joined: 06-07-07
Posts: 1,846
Likes: 0
From: Laredo, TX
thats cheap man and rice. Love the white though
Reply

Thread Tools
Search this Thread

All times are GMT -4. The time now is 06:46 AM.