Speed Cameras coming in Cedar Rapids
#1
Senior Member
Thread Starter
Speed Cameras coming in Cedar Rapids
I'm sure many of you knew already. I don't speed often in Cedar Rapids limits, at least no more than the general speed of traffic which is often over the speed limit. I'm almost certain the two on I380 will be in the Quaker Oats / St. Lukes Hospital area.
Last edited by Zander916; 12-06-2009 at 04:09 PM.
#5
Senior Member
Join Date: 06-25-08
Location: Yulee, Florida
Posts: 7,155
Likes: 0
Received 0 Likes
on
0 Posts
i know edgewoods got 2 lanes, im saying its not a good road for speeding, there going to be issuing tickets for keeping up with traffic, its not like 380 where you can fly
#6
Senior Member
Thread Starter
Don't forget that with the exception of the I380 cameras and the mobile all of them will also catch red light runners. That's probably why some of those congested intersections were chosen. People will not only run the red but speed up to do it.
Plus like, the NB Collins Rd ramp coming off Center Point rd. People are always "racing" there because it goes down to one lane and it's usually congested.
Plus like, the NB Collins Rd ramp coming off Center Point rd. People are always "racing" there because it goes down to one lane and it's usually congested.
#10
Senior Member
Thread Starter
I saw the two on 380 tonight.
In the SOUTHBOUND lanes it is just on the south side of Quaker Oats. I think it's the entrance ramp of 1st Ave. E.
In the NORTHBOUND lanes it's just before the bridge... just after the Diagonal Drive / 8th Ave exit.
So basically don't speed anywhere near St. Lukes / Quaker Oats. I usually don't anyway or try not to but man... a LOT of people do!
In the SOUTHBOUND lanes it is just on the south side of Quaker Oats. I think it's the entrance ramp of 1st Ave. E.
In the NORTHBOUND lanes it's just before the bridge... just after the Diagonal Drive / 8th Ave exit.
So basically don't speed anywhere near St. Lukes / Quaker Oats. I usually don't anyway or try not to but man... a LOT of people do!
Last edited by Zander916; 01-20-2010 at 02:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post