yay! updates FTW!!!

 

y cant u send me one too..seriously.

 

So I'm guessing it wont be ready for the show this weekend.

 

I was out all weekend, sorry about the delay, I just PM'd you about rushing the prototype to you...

We can customize this part with no problem

right after the 2.4 is completed, we'll jump into the 2.2 cover

 

PM'd back....

 

thank you i let u know when im boosted

 

Here is the final spark plug cover for the 2.4 Ecotec and it's now ready for sale directly on our website

http://mrzperformance.vstore.ca/prod...roducts_id/133

 

im on the fence about it. would really need to see it in person

 

p.s. take off that oil cap spacer.

 

better than nothin!!! i like it... plus my valve cover is black so itll be a nice touch

 

not what I expected, and more $65 im not sure about it.

 

not quite what i expected either but it's not bad

 

Pass.

 

hmm it is better, but still looks like the first one.

 

not much else they could do, just by the way the valve cover and coil packs sit.

 

yes but I think they should make it bigger so that it covers the whole engine.

 

I agree if it coverd the hole valve cover it might look better.

 

hmm something like the astra valve cover with ecotec in the corner.. this really isn't bad either but i think i need to see it in person

 

yo someone buy it in ny and come to the ny meet so i can see if i want it or now..haha

 

Agree!!
I'm not sure about it. It's ok but like some others, I would have to see it in person

 

I'm going to get it. A paper sac would look better then it does now. Think I might get the oil cap cover as well.

 

you guys are too picky. What your stating you want is exactly what the first design was and nobody liked it. It just about covered the whole valve cover. What i would like to see is something I made myself.

I rigged up a piece of sheet metal, measured and cut it so it sat in between the coils, bolted on using the 4 coil bolts, and I painted in black. You obviously still see the top of the coils but they dont stick out nearly as much, the problem with the valve cover is not the coils sticking up, but the big recess between the 2 sides. What my design was is pretty much what was discussed the page after the first design was released

heres a rough MS paint drawing



Red dots donate locations of bolts

 

i think waht redfocz was thinkin was something more like this



but flat and metal lol

 

O....more power to him + that thing would prolly cost like $500 from MRZ lol

 

yea your probably right