Hey guys! I currently have the INTENSE poly transmission mounts installed. I would like to go back to the stock front and rear transmission mounts. The way this works easiest, is for someone to send me their entire front and rear transmission mount (mounts with stock bushings still installed), and just the cost of shipping to me, and then I'll send my mounts (with the INTENSE poly bushings installed) back. This is a good deal for someone who's looking to firm up the shifting and get rid of wheel hop, as you aren't paying anything for them! By doing it this way, you are making the install alot easier for yourself, as there's only 6 bolts (3 for the front and 3 for the rear) total to remove the mounts. Take care.

 

pm sent

 

PM Replied.

 

may I ask why you are removing them?

 

i will do this if you still have them

 

There's nly 6 bolts total? Hmm thats odd, I swear I just removed my solid mounts and took out: 3 for the front and 6 for teh rear + the 7th bolt that holds the bushing of the rear mount to the brace that connects to the tranny.

 

I think you're right. There were 3 other small bolts. Regardless, it's still much easier to do it this way than to remeove the mount, then the bushing (which is the tough part).

These ARE still available for trade.

 

Sure! I don't like the vibrations. The vibrations aren't real bad, not as bad as an engine mount, but still noticeable.

 

did they help with the wheel hop or was the difference not worth the vibration issues on a daily driver?

 

Yes, they helped with wheelhop temendously! I don't have any wheelhop with the CAB's and these.