Im selling a coupler adapter for BOV's with a 1.25" bung. each end of the adapter is 2.5". will fit all current charge piping for the SSTC's. This is a no weld option for mounting a BOV. Im located in the Long Island and will be cheaper if picked up. i accept paypal aswell.

BPV Delete Plate has been sold to Gestapo007.
The BOV has been sold to ELECBlu06.

I now have just the adapter for sale. asking 25shipped to any interested party.

 

i want your blockoff plate

 

That block off looks different than mine. I guess I have an older version because it doesnt have that little cut out part at the bottom. Made it kind of a bitch when I was putting my intake on.

 

how much you looking to spend? 25shipped sound good?

 

I got 2nd dibs on the Block off plate if Gestapo and his sexy ass freshly painted car doesnt get it lol.

 

His car does look damn good!!

 

Yes it does!

 

25 shipped is a deal my friend. PM me your paypal. and thanks guys!

 

what does that BOV sound like i already have one but i have HAHN CP and i ordered the flange but i have to get it welded in. with this i dont have to weld it so this is a option for me i guess.

 

it kinda barks when you close the throttle at full boost. Was quite pleasant. ill try to find a video thats close to it

 

Badbaltguy is running this BOV i think, look up his vid's hes got a bunch. I think this is one of the nicest sounding ones if i can remember

 

BUUUUMMMPPPP pssssshhh BUUUMMPPP

 

bump for my block off plate <3

 

bizzump

 

im confused? is this a way of running a bov without charge pipes? instead you use the coupler?

 

i run the CIA charge piping, on the where CIA uses a coupler on between the pipe from the turbo and the pipe from the intercooler. thats where i put this coupler. If you have the hahn charge piping, you put it right after that small pipe leading off the turbo.

my set up was turbo-long pipe- bov/coupler- shortpipe- intercooler.

this is the no welding way to do it. I forgot to mention, this coupler is 2.5" in and out

you could in theory use this on the stock piping, but youd have to find a spot with at 2.5" OD and cut it with a dremel

 

So in theory I could just buy the cold side pipe and use this coupler and get my ssqv. Then all I would need is a block off plate... Correct me if I'm wrong

 

if your ssqv has a 1.25" mounting flange, same as pictured on the HAHN BOV, then yes, this coupler would work for you

ohh, COLD SIDE, didnt read your post properly, there might be fitment issues around the intercooler connection, its kinda tight under there and the throttle body is a 2.75 or 3" i forget which, so it wont work there. this coupler is better used on the hot side.

 

pmed

 

umm...probobly not on the cold side pipe with this. Thats a very short routed pipe and i dont think it has the extra space to put a Coupler like this in there anywhere. That piping is only a few feet and mostly bends. I would put something like this on the hot side pipe.

 

hey gestapo, did the plate come in?

 

Yes sir Thank youuu! Just had to take it off today though and ugh, long story

 

pmed again.. i'm taking the BOV