[SOLD]Asking $250 shipped in the lower 48 OBO. These are $750 or so new. Need it gone.

I don't know much about turbos, so if you have any questions feel free to ask and I'll do the legwork to figure it out. It says Turbonetics on the inlet housing which has J1702 stamped into it. The inlet is 2.75" on its OD, and the outlet is 2" on its OD. The exhaust housing has a four bolt rectangular flange with 20357 cast into it.

I never ran it; merely acquired it in a deal, and was told it needed seals.

 

Price updated after more research.

 

it would help you sell it if you pulled the housings off and measured both wheel's inducers/exducers

 

Thanks for the advice.

Compressor:

Exducer- 76mm
Inducer- 54mm


Turbine:

Exducer- 58mm
Inducer- 49mm

 

There ya go! That's a pretty good sized turbo for anyone looking to make mid to high 300's

 

That's exactly what I was assuming. The guy I got it from said it would work great on my car, but I'm going to rock the TVS for a couple more seasons before I switch to the darkside.

Thanks again for the suggestion.

 

So, this would need a t3 flange manifold and a wastegate right?

 

Correct.

 

Still available. Make me a reasonable offer.

 

ttt

 

Price lowered to $250 OBO. Need this gone.