GT rear valence For a cobalt
#1
Senior Member
Thread Starter
Join Date: 03-09-07
Location: Ohio
Posts: 934
Likes: 0
Received 0 Likes
on
0 Posts
GT rear valence For a cobalt
Ok i have a cobalt 2.4 and i would love to swap not the whole bumper but the rear valence cover or the "ground effects" on the back bumper.
i would like a black one so i wont have to paint
will this work first and formost? and if someone wants to trade straight up lmk
i would like a black one so i wont have to paint
will this work first and formost? and if someone wants to trade straight up lmk
#4
Senior Member
iTrader: (3)
Join Date: 12-02-07
Location: Edmonton
Posts: 8,977
Likes: 0
Received 0 Likes
on
0 Posts
The G5 GT lip fits the base G5 bumper (and thus I'd assume it fits the base Cobalt bumper). The SS 2.4 has its own bumper... not sure it would fit.
It might somehow squeeze on there but it's not gonna be perfect, for that you'd need to switch to a base Cobalt rear and at that point it becomes a worthless endeavour.
It might somehow squeeze on there but it's not gonna be perfect, for that you'd need to switch to a base Cobalt rear and at that point it becomes a worthless endeavour.
#5
Buy this(#'s 11&12)- http://www.gmpartsdirect.com/catalog/frameset.cfm
Use this how-to- https://www.cobaltss.net/forums/show...ve+front+plate
Use this how-to- https://www.cobaltss.net/forums/show...ve+front+plate
#8
Senior Member
iTrader: (3)
Join Date: 12-02-07
Location: Edmonton
Posts: 8,977
Likes: 0
Received 0 Likes
on
0 Posts
Buy this(#'s 11&12)- http://www.gmpartsdirect.com/catalog/frameset.cfm
Use this how-to- https://www.cobaltss.net/forums/show...ve+front+plate
Use this how-to- https://www.cobaltss.net/forums/show...ve+front+plate
#9
#10
Senior Member
iTrader: (3)
Join Date: 12-02-07
Location: Edmonton
Posts: 8,977
Likes: 0
Received 0 Likes
on
0 Posts
Probably wouldn't be the same principle since those little slots for you to cut might not be there, or in the same place.. I haven't looked at a GT rear lip. It might be a little bit small since, again, the lip fits the bottom of the base bumperz. It probably fits okay, I just wanted to mention it in case someone tried using that how-to and it failed them.
Thread
Thread Starter
Forum
Replies
Last Post
QuickSilver_SS
08-10 SS Turbocharged General Discussion
2
09-17-2015 05:38 PM
QuickSilver_SS
Wanted - What to buy - All categories
0
09-17-2015 11:23 AM