Car jerking wildly!
Senior Member
Joined: 09-02-09
Posts: 4,210
Likes: 2
From: Wisconsin
Ok, im not sure why but sometimes my balt will jerk forward and back when im in first gear just trying to slowly drive by people when leaving a gas station or anything that requires you to go under 10, and when this happens I can either slam the gas down and drive like a bat out of hell or shift into second gear and have the rpms fall so low that it feels like my car aint moving. This dont seem to happen if im going 50% to wot in first gear it only seems to do it when im only giving it a lil gas. Besides it being ******* embarrassing as hell id like to know whats wrong with the car to fix it.
My dad's Ranger, and my brother S-10 both do (did) that too, as well as my Cobalt
I think it has something to do with the low speed (Less rotational momentum) on theflywheel combined with the engine giving power in spurts/bursts. IE: Cylinder 1's power stroke, then Cylinder 3, then Cylinder 4, then Cylinder 2, then Cylinder 1 again. A 4 cylinder engine will always have 1 cylinder on power stroke, but there isnt any transition, like there is on say a 7 cylinder radial engine. Wich when that runs at low RPM like many radial engines they putter and sputt and bounce too.
It's normal for EVERY manual car. It's just the slop of the trans mounts from the torque in first gear if you have trans/engine mounts or torque damper this "rubber band" effect is eliminated. Ask me how I know.
Senior Member
Joined: 06-10-10
Posts: 1,660
Likes: 2
From: Upstate, SC
Its a combo of clutch disk springs, engine mounts, axle slop, and control arms all flexing and unloading and a crappy stock tune and LOTS of gear... a little extra slip of the clutch usually helps stop this, or a non-emmisions friendly tune... i think i pulled 5* of timing and added 10% fuel in my mustangs tune below 1800rpm to make it drive better...
Thread
Thread Starter
Forum
Replies
Last Post