Clutch Problem.... Slave Cylinder perhaps?
Thread Starter
Senior Member
iTrader: (5)
Joined: 03-17-06
Posts: 5,170
Likes: 1
From: Bay Area, Cali
Clutch Problem.... Slave Cylinder perhaps?
Go to start up the balt this morning, have it parked in gear.
Push in the clutch, turn the key, pops out of gear, clutch petal is limp.
Roll er' in the garage, jack her up... see small amount of fluid dripping between the bell housing and block.
Thoughts? Questions? Comments?
Master cylinder looked fine and didnt appear to be leaking.
I really dont want to pull the tranny again lol.
bump
Push in the clutch, turn the key, pops out of gear, clutch petal is limp.
Roll er' in the garage, jack her up... see small amount of fluid dripping between the bell housing and block.
Thoughts? Questions? Comments?
Master cylinder looked fine and didnt appear to be leaking.
I really dont want to pull the tranny again lol.
bump
Last edited by Beck; Jun 3, 2008 at 08:27 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
Jesse
Problems/Service/Maintenance
2
Sep 28, 2015 12:51 PM