Ok here's the deal. I'm near Atlanta Ga right now out for a friend of the family. Let the wife drive for a little while, she's not good at driving my ss/sc, she went to take off car jerked a few times and died. Restarted and went on our way. On the highway the cruise wouldn't work. Later on the cel is on. So I get the codes read and it's evap canister solenoid, maf low current, both o2 sensora. I don't remember the exact codes. What I've tried so far: cleaning the maf, replacing the solenoid. it's somewhat better but still is jerky on take offs and no cruise? I really need some help to try to get this resolved. I'm like 700 miles from home So it sucks

 

Check your third brake light for bad bulbs, that generally can make cruise not work

 

Checked that awhile back. all bulbs are working, afr is about normal.

 

I think I have fixed it I replaced the maf. Pulled the battery cable and seems to back to normal.

 

Sounds like a coincidence.. if not bad bulbs, cobalts are nutorious for sticky brake switches.. so tap the brakes a few times and try the cruise again.. as far as the other things, it could be just about anything..

 

when i had my ss/sc I had to change the vacuum line. It was dry rotted.

 

Do you know the size of the line? I know there a few different sizes

 

Check the EXH fuse under the hood. I had a lot of those codes when it blew from an o2 sensor wire melting on the downpipe.

 

This right here was my whole problem. I didn't read this post until I had made it home. Once I checked this fuse then replaced it, Car is normal again. Thank you so much wish I had seen this sooner.