Unfortunately I must have over looked the part about putting the spacers in when I was installing my OTTP Stage 2 Transmission mounts..
As you can see..
The rear mounting bracket pictured here

Used to be one piece.. Now it's two.


Okay and pictured here you can see the Spacers that were supposed to be installed, but weren't..





The front mount.. Not pictured.. The bracket just bent and it's not bending back out anytime soon.. So it's holding just fine without spacers, fortunately.


So I need a new mounting bracket for the rear transmission mount..

Where to buy where to buy.

 

use this site to get the part numbers then shop around.....Chevrolet (Silverado , SUBURBAN , Tahoe , AVALANCHE , TRAILBLAZER , COLORADO , EXPRESS , S10 , BLAZER , K1500 ) parts

 

If the part number is labeled on the bracket then it's GM15816119

Thanks

 

They don't ship to APO

checking gmpartsdirect.... it's cheaper there hmnn

 

Unfortunately they don't offer express shipping.. But GMpartsdirect was cheaper than what I've found.

 

PM Tom@CED. I would say call, but since you're in Germany that might get pricy. lol

Just guessing, but since they rock, they might be able to help you out and working something out with the APO thing.

 

oh
I already ordered the bracket..
I don't know why I didn't think of putting them on when I saw how much space there was between the bracket and the mount.

 

SO far the little bit of driving that I had to do has been okay.. I'm letting Cait rest for a bit until the part comes in the mail..

So embarrassing.

 

that aint ****. my boy just bought a 2010 ms3 with 13k on the ticker... 3 weeks later his motor fell out. that is not a joke. the whole passenger side went thru the axle and input shaft and hit the ground coming to a grinding hault in center city philly on a friday night haha.

 

Oh mann How did that happen??

I ordered a new bracket already then it will be good to go..


What sucks is that my pulley puller came in today.. So I'll install the 2.6.. and not be able to drive LOL