Wiring
Thread Starter
New Member
Joined: 12-29-06
Posts: 4
Likes: 0
From: New York
Wiring
Hello.
I'm new to the forum, but I come seeking a bit of advice.
Just installed new projectors into my 2006 Cobalt SS, and while I was busy reattaching the bumper to the car, I left my fellow hard-worker to splice for the halos, and the like.
Regardless, he finished it up, (by splicing every single wire until he hit Brown). With the Halos wires grounded and working fine, he proceded to clump all of the other wires together and tape around them all.
When I started the car back up, I got "Service Air Bags", no turn signal, and no outside temp-gauge. (Instead I got a ---- where the temperature should go.)
You think just re-taping the wires would fix the problem?
I'm new to the forum, but I come seeking a bit of advice.
Just installed new projectors into my 2006 Cobalt SS, and while I was busy reattaching the bumper to the car, I left my fellow hard-worker to splice for the halos, and the like.
Regardless, he finished it up, (by splicing every single wire until he hit Brown). With the Halos wires grounded and working fine, he proceded to clump all of the other wires together and tape around them all.
When I started the car back up, I got "Service Air Bags", no turn signal, and no outside temp-gauge. (Instead I got a ---- where the temperature should go.)
You think just re-taping the wires would fix the problem?
Thread
Thread Starter
Forum
Replies
Last Post