lets start an offical slammed thread .......
I forgot what they are the shop ordering them for me has got me so out of wack... i wanted B&G or Progress, and then he started saying all this ****, and mentioned eibach...so idk..im def nt getting sporlines though...that doesnt even looked lower it just looks like someone threw abunch of bodies in the truck.
got damn thats SLAMMED! i haz the same kit but im not brave enough to lower my **** that low plus the rear bump stops were fucken touching so i raised the rears a bit cus i was a ***** and i didnt know what was going to happen.


I forgot what they are the shop ordering them for me has got me so out of wack... i wanted B&G or Progress, and then he started saying all this ****, and mentioned eibach...so idk..im def nt getting sporlines though...that doesnt even looked lower it just looks like someone threw abunch of bodies in the truck.
Saw this car in the "Show off your aftermarket wheel thread". Im seriously looking to get this low, would ksports be able to do this? These are 17's with 215/40 as stated by the person who posted this car in the thread. I have 17's and would want a bit meatier tire but less than a 215/45 maybe a 205/45.

Maybe I would go a bit higher, not much.

Maybe I would go a bit higher, not much.
Did I just Jizz? ... I believe so. Give me some info on that shiz..i wanna be that low. or the lt above this comment. it looks pretty good.
I wanna play.
Don't mind the rust. It was owned by someone up north before coming into my possesion. Anywho, my center sub-frame brace is less than 1" from the ground and gets caught up if I drive on gravel.....lol.

Pinch welds are about 2" off the ground.

And the whole car. Sorry, I like to ***** this shot out, because quite frankly it's the only decent picture I have of my car basically....haha.

Oh and here was a shot of when I bought it bone stock, pre-slam. I kind of miss the driveability, but I will never go back to dook status ever again!
Don't mind the rust. It was owned by someone up north before coming into my possesion. Anywho, my center sub-frame brace is less than 1" from the ground and gets caught up if I drive on gravel.....lol.

Pinch welds are about 2" off the ground.

And the whole car. Sorry, I like to ***** this shot out, because quite frankly it's the only decent picture I have of my car basically....haha.

Oh and here was a shot of when I bought it bone stock, pre-slam. I kind of miss the driveability, but I will never go back to dook status ever again!













