Need help logging w/ Wideband using HPT STANDARD
#1
Senior Member
Thread Starter
Join Date: 03-09-08
Location: Brandon, Florida
Posts: 1,934
Likes: 0
Received 0 Likes
on
0 Posts
Need help logging w/ Wideband using HPT STANDARD
I have searched and read through some threads but I can't seem to find a how to on logging my Innovate Wideband using HPT Standard. I know it has something to do with the A/C pressure switch or something to that effect. Any good directions or links would be greatly appreicated. Thanks
#2
Senior Member
Join Date: 06-01-07
Location: Chicago, IL
Posts: 1,417
Likes: 0
Received 0 Likes
on
0 Posts
Wire the 0-5v output signal wire from the afr guage to the ac pressure sensor
The ac pres sensor is the little connector that plugs into the ac compressor, I think it is the red a black wire
After that set up a user defined pid for the afr refrencing the ac pressure sensor
There is a how to on here somewhere
The ac pres sensor is the little connector that plugs into the ac compressor, I think it is the red a black wire
After that set up a user defined pid for the afr refrencing the ac pressure sensor
There is a how to on here somewhere
#4
Senior Member
Join Date: 06-01-07
Location: Chicago, IL
Posts: 1,417
Likes: 0
Received 0 Likes
on
0 Posts
whoa, thats wierd, i just tried to find the how to again, and it seems like its gone. It used to be a sticky in the tuning section but i can't seem to find it anywhere
#5
New Member
Join Date: 07-13-08
Location: syracuse ny
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
#11
New Member
Join Date: 01-05-08
Location: Asheville, NC
Posts: 128
Likes: 0
Received 0 Likes
on
0 Posts
#12
Senior Member
Join Date: 07-16-08
Location: Boynton Beach, Fl
Posts: 5,610
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
2.0 LSJ Engine: aem wideband,zzp front mount exhanger,stock exchanger
n20saturn
Parts
7
09-30-2015 12:26 AM